Sony PCM-D10 Service Manual page 19

PCM-D10
LINE OUT JACK CHECKING METHOD
When the following target part replaced with new part, follow the
procedure in this section to check the LINE OUT jack.
Target part:
Complete MAIN board
Complete HP_LINE_JACK board
Beforehand preparation:
Prepare the following equipment etc.
• AV amplifi er or playback device (analog)/speaker (commercial
products)
• Audio cable (commercial products)
• Size AA batteries (4)
Open the battery lid on the rear side of main unit, install the four
size AA batteries.
LINE OUT jack checking procedure:
1. Turn the power on by turning ON of the [POWER] switch on the
left side of main unit.
2. Connect the audio cable to the AV amplifi er or playback equip-
ment (analog) that you prepared in advance and connect it to the
LINE OUT jack of this unit.
AV amplifier
or playback
Speaker
device (analog)
To audio input
terminal
To LINE OUT
jack
Audio cable of
commercial products
19
Speaker
3. Press the [ BACK/ HOME] button for about 1 second or longer
to display the home menu.
4. With "Record" selected, press the [
[
N
5. In the state of step 4 (recording standby), press the [OPTION]
button to open the option menu.
[OPTION] button
6. Press the [ DPC]/[ A-B
v
Folder" in the option menu and press the [
sion.
REC Information
Recording Folder
Create Folder
Rec Mode
Stereo/Monaural
Peak Hold
LCF(Low Cut)
7. Select the memory (Built-In Memory or SD Card) and folder
you want to save the recording.
(The fi gure below is a reference example)
Memory Selection
Built-In Memory
SD Card
Sony CONFIDENTIAL
For Authorized Servicer
HOME
Record
Recorded Files
Music
Bluetooth
Settings
] button to decision.
N
HOME
Record
Recorded Files
Music
Bluetooth
Settings
] button
REC Information
Recording Folder
Create Folder
Rec Mode
Stereo/Monaural
Peak Hold
LCF(Low Cut)
] buttons to select the "Recording
V
] button to deci-
N
Built-In Memory
FOLDER01
FOLDER02
– Continued on next page –
SYS SET