Table of Contents
Advertisement
PCM-D10
DESTINATION SETTING METHOD
When the following target part replaced with new part, set up the
destination according to the procedure in this section.
Target part:
Complete MAIN board
IMPORTANT:
Be sure to select the correct destination. It is a compliance viola-
tion to change the destination to other regions.
Note 1: The information which are not opened to customers are
included in the destination setting method. After you are
cautious of handling of information, execute work under
the suffi cient administration.
Note 2: There is a step of executing "Factory Shipment" in the
destination setting method. Executing "Factory Shipment"
will initialize the built-in memory fi les and settings. Backup
the built-in memory fi les to a PC or SD card beforehand.
Beforehand preparation:
•
Open the battery lid on the rear side of main unit, install the four
size AA batteries.
Note 3: Use the following batteries so that the batteries will not run out
during work.
New alkaline battery
or
Fully charged Ni-MH battery
•
Refer to "BACKUP OF THE BUILT-IN MEMORY FILES" on
page 5, be sure to backup the fi les have been recorded in the
built-in memory beforehand.
Destination setting procedure:
1. Turn the power on by turning ON of the [POWER] switch on the
left side of main unit.
8
2. Turn the stopped state by pressing the [
side of main unit.
3. Refer to "1. SETTING THE TEST MODE" on page 51 and set
the this unit to test mode.
4. Turn off the [HOLD] switch with state displayed the test mode
menu.
5. Press the [
DPC]/[ A-B
v
Dest" and press the [
] button to decision.
N
[
DPC]
v
button
[
N
[
A-B
button
6. Press the buttons in the following order.
DPC] t 3 [VOL −] t 4 [ A-B
1 [VOL +] t 2 [
v
[VOL –] button
3
[
A-B
] button
V
4
Sony CONFIDENTIAL
For Authorized Servicer
STOP] on the front
x
[
STOP] button
x
] buttons to select the "Setting
V
BT
NFC
Audio Loop
Sine Wave
INT Mic Check
Setting Dest
Debug Mode
Chg Info
To Normal Mode
[Current Dest]
E
Select : Up/Down
Save
: Play
E
] button
]
V
[VOL +] button
1
[
DPC] button
v
2
– Continued on next page –
]
V
SYS SET
Advertisement
Table of Contents
