Table of Contents
Advertisement
PCM-D10
2-4.
ORNAMENT (REC VOL), KNOB REC VOL ASSY, L KNOB (REC VOL)
Note 1: When the knob REC VOL assy and L knob (REC VOL) are installed,
refer to "2-5 CHECKING OPERATION OF THE KNOB (REC VOL)"
on page 27.
top side
1 Pull out the knob REC VOL
assy in the direction of the
arrow.
6 knob REC VOL assy
5 screw (M1.4)
(L = 2.5 mm)
• How to install the knob REC VOL assy
When installing the knob REC VOL assy,
align the hole and shaft of the D cut shape.
hole
knob REC VOL assy
26
hole (position of
scale mark "6")
hole (position of
scale mark "0")
7 L knob
(REC VOL)
block
shaft
2 Insert a flat blade screwdriver into
the holes, and use it to push out
the claws of the ornament (REC VOL)
to remove the ornament.
hole
R knob (REC VOL)
hole
2 Insert a flat blade screwdriver into
the holes, and use it to push out
the claws of the ornament (REC VOL)
to remove the ornament.
8 claw (narrow)
(total six claws)
outside
(knob REC VOL
assy side)
• Installation direction for the rubber (REC VOL)
– Outside –
Sony CONFIDENTIAL
For Authorized Servicer
3 two
4 ornament
claws
(REC VOL)
hole (total six holes)
0 L knob
(REC VOL)
9 rubber (REC VOL)
Note 2: When installing the rubber
(REC VOL), align the six
holes and six claws (narrow).
claw (narrow)
– Inside –
(total six claws)
claw (wide)
(total six claws)
inside
(unit side)
SYS SET
Advertisement
Table of Contents
