Starter - Kubota WG972-E2 Workshop Manual

WG972-E2, DF972-E2, WSM

(8) Starter

1. Unscrew the C terminal nut (6), and disconnect the connecting lead (11).
2. Unscrew the solenoid switch mounting nuts (1), and remove the solenoid switch (5).
3. Remove the end frame cap (16).
4. Remove the break shoe (15), break spring (14) and gasket (13).
5. Unscrew the through bolts (21), and remove the rear end frame (12).
6. Remove the brush from the brush holder while holding the spring up.
7. Remove the brush holder (20).
8. Draw out the yoke (18) from the starter drive housing (2).
9. Draw out the armature (9) with the drive lever (3).
■
NOTE
• Do not damege to the brush and commutator.
(When reassembling)
• Apply grease (DENSO.CO.LTD. No. 50 or its equivalent) to the parts indicated in the figure.
- Joint of solenoid switch (a)
- Bushing (b)
- Drive lever (c)
- Collar (d)
- Teeth of pinion gear (e)
- Armature shaft (f)
Tightening torque C Terminal Nut
5.9 to 11.8 N·m
0.6 to 1.2 kgf·m
4.3 to 8.7 ft-lbs
S-49
GASOLINE / LPG ENGINE
(1) Solenoid Switch mounting Nut
(2) Starter Drive Housing
(3) Drive lever
(4) Gasket
(5) Solenoid Switch
(6) C Terminal Nut
(7) Snap Ring
(8) Overrunning Clutch
(9) Armature
(10) Brush Spring
(11) Connecting Lead
(12) Rear End Frame
(13) Gasket
(14) Break Spring
(15) Break Shoe
(16) End Frame Cap
(17) Screw
(18) Yoke
(19) Brush
(20) Brush Holder
(21) Through Bolt
W1224079
KiSC issued 01, 2006 A