Kubota WG972-E2 Workshop Manual page 96

WG972-E2, DF972-E2, WSM
Ignitor Check Chart
Negative
A
Positive
A
B 10 to 40 kΩ
C 10 to 40 kΩ
D 11 to 47 kΩ
E infinity
2 megohm
F
(minimum)
2 megohm
G
(minimum)
2 megohm
H
(minimum)
■
NOTE
• This check sheet shows the results of the test conducted by using the "FLUKE MULTMETER 110 SERIES"
(degital meter).
• Use of other testers than those above may show different measured results.
Resistance of Ignitor
1. Disconnect the connector.
2. Measure the resistance with an ohmmeter.
3. If the resistance is not with in the factory specifications, replace it.
B C
10 to 40 kΩ 10 to 40 kΩ
0.33 to 1.3 kΩ 1.8 to 7.3 kΩ
0.33 to 1.3 kΩ
1.8 to 7.3 kΩ 1.5 to 6.0 kΩ
infinity infinity
2 megohm 2 megohm
(minimum) (minimum)
2 megohm 2 megohm
(minimum) (minimum)
2 megohm 2 megohm
(minimum) (minimum)
D E
11 to 47 kΩ infinity
infinity
1.5 to 6.0 kΩ infinity
infinity
infinity
2 megohm
infinity
(minimum)
2 megohm
infinity
(minimum)
2 megohm
infinity
(minimum)
S-26
GASOLINE / LPG ENGINE
W1109304
F G H
infinity infinity infinity
infinity infinity infinity
infinity infinity infinity
infinity infinity infinity
infinity infinity infinity
infinity infinity
infinity infinity
infinity infinity
KiSC issued 01, 2006 A