Check Points Of Every 200 Hours - Kubota WG972-E2 Workshop Manual

WG972-E2, DF972-E2, WSM

[5] CHECK POINTS OF EVERY 200 HOURS

Changing Engine Oil
CAUTION
• Be sure to stop engine before changing engine oil.
1. Start and warm up the engine for approx. 5 minutes.
2. Place an oil pan underneath the engine.
3. To drain the used oil, remove the drain plug (1) at the bottom of
the engine and drain the oil completely.
4. Screw the drain plug (1).
5. Fill new oil up to upper line on the dipstick (2).
■ IMPORTANT
• When using an oil of different maker or viscosity from the
previous one, remove all of the old oil.
• Never mix two different types of oil.
• Engine oil should have properties of API classification SH.
• Use the proper SAE Engine Oil according to ambient
temperature.
Above 25 °C (77 °F)
0 °C to 25 °C (32 °F to 77 °F)
Below 0 °C (32 °F)
Engine oil capacity
Tightening torque Drain plug
(1) Drain Plug
Replacing Engine Oil Filter Cartridge
CAUTION
• Be sure to stop the engine before changing filter cartridge.
1. Remove the oil filter cartridge (1) with the filter wrench.
2. Apply a slight coart of oil onto the new cartridge gasket.
3. To install the new cartridge, screw it in by hand. Over tightening
may cause deformation of rubber gasket.
4. After the new cartridge has been replaced, the engine oil
normally decrease a little. Thus see that the engine oil does not
leak through the seal and be sure to read the oil level on the
dipstick. Then, replenish the engine oil up to the specified level.
■ IMPORTANT
• To prevent serious damage to the engine, replacement
element must be highly efficient.
genuine filter or its equivalent.
(1) Engine Oil Filter Cartridge
Checking the Setting of LPG Fuel Tank (DF972-E2)
Check the setting of LGP fuel tank.
G-12
G GENERAL
SAE30 or SAE10W-30
SAE20 or SAE10W-30
SAE10W or SAE10W-30
3.4 L
3.59 U.S.qts
32.4 to 37.3 N·m
3.3 to 3.8 kgf·m
23.9 to 27.5 ft-lbs
(2) Dipstick
Use only a KUBOTA
W1036804
W1015117
KiSC issued 01, 2006 A