Array Detector Mounting Instructions; Mount An Array Detector To The Isoplane - Teledyne Everywhereyoulook IsoPlane 320A Manual

32
Install the grating turret that has been shipped in the same shipping box with the
5.
IsoPlane but is packaged outside the IsoPlane housing to protect the gratings during
shipment. Refer to
information.
Turn on the power switch on the IsoPlane power supply and the IsoPlane should
6.
initialize to zero wavelength. Refer to
information about operating the IsoPlane using Princeton Instruments' software.

5.3 Array Detector Mounting Instructions

The standard mounting plate for CCDs, FPAs, and diode arrays accommodates detectors
with a slotted flange or mounting holes aligned on a 3.60" bolt circle pattern. There are six
(6) equally spaced #10-32 tapped holes on a 3.60" bolt circle designed to accept #10-32 hex
head screws. See
Figure 5-2: Typical Mounting Plate
R
A
DJUSTMENT
5.3.1

Mount an Array Detector to the IsoPlane

The array detector mounting plate is mounted to the entrance port of the IsoPlane.
Perform the following procedure to mount an array detector to an IsoPlane
Remove the shipping cover from the mounting plate.
1.
If the detector has a three-slotted flange (3.60" bolt
2.
circle,) perform the following procedure to mount the
detector:
a.
Section 3.1, Turret
Figure 5-2.
OTATIONAL
S
LOTS
Screw three (3) #10-32 x ½ hex head bolts into the
¼
plate. Leave -inch of thread exposed.
Installation, on page 15 for complete installation
Chapter 6, Operation, on page 43 for complete
(3) 10-32 T D
HREADED ETECTOR
M H ( U
OUNTING OLES TYPICALLY
)
SED
R
OTATIONAL
A
DJUSTMENT
S
LOTS