Accessories; Commissioning - Bosch Rexroth IndraControl VDP 16.3 Project Planning Manual

IndraControl VDP 16.3, VDP 40.3, VDP 60.3 Operator Display
VDP with Touch Screen and Customized Design
1.3

Accessories

1.4

Commissioning

Fig. 1-3: VDP with touch screen and customized design
Using the Y-repeater (VAC01.1S-YD1-NNNN) provided as accessory, two
VDP displays can be connected to the control cabinet PC with CDI interface.
The Y-repeater can be cascaded. Therefore, three or more VDPs can be
connected to a control cabinet PC with CDI interface. Also refer to the
operating instructions on the Y-repeater: R911336973.
The Y-repeater can only be connected to a control cabinet PC
with CDI interface. An operation at the control cabinet PC with
CDI+ interfaces is not possible.
Mount the device properly (see
Wiring" on page 17). Connect the device to the de-energized control
cabinet PC; then connect the 24 V supply voltage.
System presentation
chapter 5 "Dimensions, Installation and
R911323862_Edition 07 Bosch Rexroth AG
5/57