Getting Started - Remington Titanium SCC100 Manual

High precision designer short cut clipper
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1

GETTING STARTED

Before using your hair clipper for the fi rst time, charge for 14-16 hours.
Your clipper cannot be overcharged. However, if the product is not going to be used for an
extended period time (2-3 months), unplug it from the mains and store. Fully recharge your
hairclipper when you would like to use it again.
To preserve the life of your batteries, let them run out every six months then recharge for
14-16 hours.
HOW TO USE
A 5-position Zoom Wheel provides a choice of cuttings lengths for a consistent trim every
time. Adjust the trimming length by rotating the Zoom Wheel to the desired position numb-
er. Refer to the chart below for the position number of your desired hair length.
2
070961_REM_IFU_SCC100_INT.indd 2
070961_REM_IFU_SCC100_INT.indd 2
ENGLISH
CHARGING YOUR HAIRCLIPPER
Ensure the product is switched off.
Connect the charging adaptor to the product and then to the mains. The charging indica-
tor will light up.
CORDED USE
Connect the charging adaptor to the product and then to the mains.
CAUTION: Extended mains only use will result in the reduction of the battery life.
BEFORE STARTING THE CUT (DIAGRAM A)
Inspect the clipper making sure that it is free from hair and dirt.
Seat the person so that their head is approximately at your eye level.
Before cutting, always comb the hair so it is tangle free and dry.
Setting
Length
1
2
3
6,5 mm
4
9,5 mm
5
12,5 mm
3 mm
5 mm
10.30.2007 7:47:41 Uhr
10.30.2007 7:47:41 Uhr

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents