Getting Started - Remington HC610 Manual

GETTING STARTED

CHARGING YOUR HAIRCLIPPER
Before using your hair clipper for the fi rst time, charge for 14-16 hours.
Ensure the product is switched off.
Connect the charging adaptor to the product and then to the mains. The charging indica-
tor will light up.
Use product until the battery is low. This is indicated by illuminated red light.
Your clipper cannot be overcharged. However, if the product is not going to be used for an
extended period time (2-3 months), unplug it from the mains and store. Fully recharge your
hairclipper when you would like to use it again.
To preserve the life of your batteries, let them run out every six months then recharge for
14-16 hours.
CORDED USE
Connect the charging adaptor to the product and then to the mains.
CAUTION: Extended mains only use will result in the reduction of the battery life.
HOW TO USE
Before starting the cut
1. Inspect the clipper making sure that it is free from hair and dirt.
2. Seat the person so that their head is approximately at your eye level.
3. Before cutting, always comb the hair so it is tangle free and dry.
ADJUSTING THE TRIM LENGTH
The comb attachment can be adjusted to give you 7 different trim lengths simply by sliding
the comb to the desired setting. On the back of the product you will fi nd a clip mechanism,
which enables you by gently pressing it, to move the comb up and down. The clip will click
into place as it reaches each setting, and the setting number will appear on the length
position indicator.
HAIR THINNER MECHANISM
Simply adjust the hair thinner mechanism by slide the stick at the top part of the product.
2
070777_REM_IFU_HC610_INT.indd 2 070777_REM_IFU_HC610_INT.indd 2
ENGLISH
11.26.2007 12:17:18 Uhr 11.26.2007 12:17:18 Uhr