Remington Titanium SCC100 Manual page 5

The Short Cut Clipper has an adjustable trimmer attachment that lets you change trim
lengths simply by rolling the clipper's Zoom Wheel.
Remove trimmer guard attachment if you want a to-the-scalp haircut or if you want to clean
the cutter assembly.
070961_REM_IFU_SCC100_INT.indd 3 070961_REM_IFU_SCC100_INT.indd 3
SELECTING HAIR LENGTH SETTING (DIAGRAM B)
Roll the Zoom Wheel toward the top of the clipper to adjust for longer length, and
toward the bottom of the clipper for shorter length. The wheel will click into one of 5
positions.
Begin trimming at one of the longest settings (#3 or #4) to avoid accidentally trimming
hair too short. As you become familiar with the settings, you can then select your desired
length setting.
TRIMMER GUARD ATTACHMENT
Note: Trimmer guard must be attached to the clipper in order to use the hair length
selector.
TO REMOVE
Be sure the clipper is in the OFF position.
While holding clipper in one hand and holding the Zoom Wheel to prevent it from turning,
gently pull the trimmer guard attachment away from the clipper. The guard can be remo-
ved and replaced on any setting.
TO REPLACE
Be certain clipper is in OFF position.
While holding the clipper in one hand, and holding the Zoom Wheel to prevent it from
turning, slide the guard over the top of the clipper until it clicks into position.
Note: The trimmer guard attachment can only be placed on the clipper one way; if it does
not fi t properly, remove and reverse it.
3
10.30.2007 7:47:42 Uhr 10.30.2007 7:47:42 Uhr