Omron E5ZE-8 E Series Manual page 6

E5ZE-8j-E
Nomenclature
Display Unit E5ZD-SDL1
5. Bank number display
4. Point (channel) number display
3. Unit number display
6. Shift indicator
7. Run indicator
8. Auto-tuning (AT) indicator
12. Shift Key
13. Unit/Point Key
Display
No. Display
1 Process Value (PV) display
2 Set Value (SV) display
3 Unit number display
4 Point number display
5 Bank number display
6 Shift indicator
7 Run indicator
8 Auto-tuning (AT) indicator
9 Heater burnout/Heater short circuit (HB/
HS) alarm indicator
10 Alarm 1 indicator
11 Alarm 2 indicator
Key
No. Key
12 Shift Key
13 Unit/Point Key
14 Bank/Display Key
15 Down Key
16 Up Key
17 Enter Key
218
Meaning
The measured temperature and the set item characters are displayed accord-
ing to the display mode.
An error message is displayed if the system has an error.
is displayed for the leftmost digit of a figure between –1,000 and –1,999.
The value that has been set is displayed according to the display mode.
An error message is displayed if the system has an error.
is displayed for the leftmost digit of a figure between –1,000 and –1,999.
The unit number that has been selected is displayed.
The point number that has been selected is displayed.
The bank number that has been selected is displayed.
Lit at the time of key shift.
Lit when the displayed unit is being controlled.
Flashes while auto-tuning is being executed.
Lit when heater burnout or heater short circuit alarm output is ON.
Lit when alarm output 1 is ON.
Lit when alarm output 2 is ON.
Meaning
Turns ON or OFF the shift indicator.
Displays the next point number while the shift display is OFF. Any invalid point
is skipped.
...
0 1 2 3
Displays the next unit number while the shift display is ON. a , b , c , d , e , and
f are displayed for the 10th unit number and the succeeding unit numbers.
0 1 2 3
Displays the next display mode while the shift display is OFF.
Displays the next bank number when the shift display is lit.
0 1 2 3 4
Decreases the set value within the available setting range. The set value de-
creases continuously if this key is pressed for 0.5 s or more.
Note: This key does not function if the key protect switch is turned ON.
Increases the set value within the available setting range. The set value in-
creases continuously if this key is pressed for 0.5 s or more.
Note: This key does not function if the key protect switch is turned ON.
Writes the set value to the E5ZE Temperature Controller.
Note: This key does not function if the key protect switch is turned ON.
1. PV display
2. SV display
11. Alarm 2 indicator
10. Alarm 1 indicator
9. Heater burnout/Heater short circuit
(HB/HS) indicator
17. Enter Key
16. Up Key
15. Down Key
14. Bank/Display Key
Maximum point
...
Maximum unit
5 6 7
E5ZE-8j-E
: All points
: All units
: All banks