Omron E5ZE-8 E Series Manual page 15

E5ZE-8j-E
J MOUNTING THE CONTROLLERS
E5ZE-8jAAMjB-E (Enclosed Type)
Side-by-side, Close Mounting
Saves space and improves wiring efficiency.
Wall Mounting
Can be mounted to places with limited depth.
Control panel
Upside
Control panel
Upside
General Mounting Precautions
The side of the E5ZE with the terminal block and connectors
must not face up, otherwise operating errors may result.
Prepare four M4 screws to mount the E5ZE to control panels.
Use flat washers and spring washers with screws to mount the
E5ZE to control panels so that the screws will not loosen.
The mounting brackets must be attached to the E5ZE with the
four M3 x 6 screws provided with the E5ZE and each of the
screws should be tightened to a torque of 0.43 to 0.58 N S m, or
4.4 to 5.9 kgf S cm.
Do not mount as shown in the following diagram.
Control panel
E5ZE-8j-E
Upside
227