Table of Contents
Advertisement
Appendix A
INTERFACE CONFIGURATION
The Interface Configuration option for the Dial Plan menu sets configuration
parameters for the end point. These parameters vary by the type of port selected.
The following section describes the configuration options available for the Async-
232 Module. The Dial Plan menus are only accessible when using terminal mode.
To access these options, select Dial Plan from the top level menu. An Async-232
port or range of ports must be assigned in the Dial Plan before it may be used to
answer incoming or initiate outgoing calls.
ASYNC-232 MODULE INTERFACE CONFIGURATION
This section describes the Interface Configuration settings for the Async-232 Mod-
ule when using the Dial Plan User Termination menus. See the Dial Plan Menu
documentation in the ATLAS User Manual for information on general configura-
tion of User Termination options.
The Async-232 Module can only serve as a User Termination end point.
61200182L1-1
Dial Plan Interface Configuration
Figure A-1. Dial Plan Menus
Async-232 Module User Manual
A-1
Advertisement
Table of Contents
