Network Fax/Tel Switching (Australia Only); Setting The Unit For Network Switch; Network Switch System Operation - Canon MultiPASS C50 User Manual

Network FAX/TEL Switching (Australia Only)

Telstra offers the FaxStream DUET capability. If you subscribe to this
service, your line is assigned two numbers: one for fax and one for
phone. When the fax number is called, the network sends a specific
ringing tone which your unit recognises and automatically handles as a
fax call. If the phone number is called, a different ringing tone is sent out
from the network so that the call is handled as a voice call. This means
that there is no switching delay at the caller's end.
Triple ring (short-short-short) for fax receiving.Three short rings, at
regular intervals.
Any ring except triple ring (depending on your switchboard) for
telephone conversation

Setting the Unit for Network Switch

Use the MultiPASS Desktop Manager to set the MultiPASS 50 for Network
Switch. For details, see the MultiPASS Desktop Manager User's Guide.

Network Switch System Operation

The procedure for using the network switch system is almost the same as
when using the unit over a normal telephone line. When you receive calls,
however, the unit will respond slightly differently as described below.
When you hear the telephone call ring pattern:
Pick up the handset and talk normally. If you hear a slow beep, it means
the call is from a fax machine trying to send a document.
Press
the handset, the unit continues to ring until the other party hangs up. If
an answering machine is connected, it takes over the call.
When you hear the fax call ring pattern (triple ring):
After the unit rings, it receives the document automatically.
If you want to receive a document without a ringing sound:
Make sure you select the Silent Receive option in the Receive Fax tab
from the MultiPASS Desktop Manager. See the MultiPASS Desktop
Manager User's Guide for more details.
5-10
Receiving Faxes
(START/COPY) to receive the document. If you do not pick up
Chapter 5