HP Open View Installation And Maintenance Manual page 125

8. Enter the network information for the appliance node and click OK. (See
9. Click OK when the following message is displayed:
Note:
10. Press Alt+C to open a command prompt window and enter the following command:
11. Enter n when the following prompt is displayed:
12. Enter n when the following prompt is displayed:
13. Enter y when the following prompt is displayed:
14. If you have followed this procedure correctly, all services on the nodes will have been
Note:
15. On the console window, click service viewer.
Continuous Access Storage Appliance Installation and Maintenance Guide
properties" on page 42 for instructions.)
The operation completed successfully. Please reboot this
machine for the changes to take effect.
Do not reboot the appliance node at this time.
Caution: Follow steps 11 through 14 carefully. Failure to do so may cause the appliance
nodes to become inoperable.
c:\rpic\utilities\pardisk.exe
Would you like to overwrite E: F: G: H: I: J: partitions?
Y/[N]
Would you like to reinitialize Drive Q for async IP
mirroring? Y/[N]
Would you like to remount shared drives and update drive
letter's registry? Y/[N]
The following message is displayed:
WARNING! Make sure all SV3000 services are stopped on both
peer nodes before you continue. Are you sure? Y/[N]
stopped. You can first verify that the services have stopped (open another command
prompt window or use service viewer on the console). When you are ready to continue,
enter y.
Wait until the pardisk command has finished before continuing with the next step.
The Services window opens.
Reinstalling the Appliance Software
"Setting network
125