Running The Casa Setup Utility - HP Open View Installation And Maintenance Manual

Running the CASA setup utility

To run the CASA setup utility:
1. Set the console display to node 0.
2. Ensure that the hp OV CASA Console window is open in administrative mode.
3. Click setup.
4. Do either of the following:
5. Enter the customer's public network information in the
6. If the customer uses IP mirroring, enter the MirrorLink network information in the
7. Click OK.
8. Reboot node 0.
9. Set the console display to node 1 and repeat steps 2 through 7 on node 1.
Continuous Access Storage Appliance Installation and Maintenance Guide
The hp OV CASA Console window opens.
The CASA setup utility window opens
If the Peer Node Settings - General box is populated with values, do not change the
IP address in the Peer IP Address box. This IP address corresponds to the network
information in the InterLink (Bottom Port) box.
If the Peer Node Settings - General box is not populated with values, do not specify
the customer's LAN in the Peer IP Address box. Use the Peer IP address specified in
Table 4 on page 42, which corresponds to the InterLink connection between the nodes.
InterLink traffic should not be directed over the customer's LAN.
LAN Interface - Onboard NIC # 1 box.
MirrorLink (Top Port) box.
If the customer is not using IP mirroring, you can accept the default values or set the IP
address to 0.0.0.0.
Completing the Appliance Setup
(Figure 11).
45