Gigaset A120 Manual page 11

Resetting the handset
You can reset individual settings and changes that you have made. Entries in the direc-
tory, the calls list and the handset's registration to the base station will be retained.
¤ u ¤ u
¤
MENU Settings OK
¤
OK
a
Cancel the reset with .
Restoring the base station
When restoring factory settings the No Radiation mode is deactivated, individual set-
tings are reset and all lists are deleted.
The date and time are retained. The answering machine (A120A only) is ready for use
approx. 15 seconds after the base has been reset.
Resetting the base via the menu
Handsets are still registered, the system PIN is not reset.
¤ u ¤ u
¤
MENU Settings OK
Resetting the base using the key on the base
All handsets are de-registered and the system PIN is reset to the original code 0000.
Carry out the following steps: Remove the mains cable from the base. Hold down the
registration/paging key on the base (
the base at the same time. Hold the key down for at least 5 seconds.
¤ u
¤
Handset OK Reset Handset
¤ u
¤ ¤ ¤
Base OK Base Reset OK
¢
page 1) and reconnect the power cable to
11
Operating the base station on the PABX/router
Operating on the router
¤ ¤
OK Reset?
When operating the Gigaset on an analogue port of a router you can reduce problems
with echoes by activating the Echo mode (
echoes, this function should be deactivated.
Operating on the PABX
The following settings are only necessary when your PABX requires them; see the user
guide for your PABX.
When entering the digits, enter them slowly one after the other.
Changing the dialling mode
P#Q5#1N
¤
MENU
0 = touch tone dialling (DTMF); 1 = dial pulsing (DP)
¤
Setting recall
Reset? OK P#Q5#1Q
¤
MENU
0 = 80 ms; 1 = 100 ms; 2 = 120 ms; 3 = 400 ms; 4 = 250 ms; 5 = 300 ms; 6 = 600 ms;
¤
7 = 800 ms
Changing pause after line seizure
You can set the length of the pause inserted between pressing the talk key
sending the phone number.
P#Q5#1L
¤
MENU
flashes: 1 = 1 sec.; 2 = 3 sec.; 3 = 7 sec.
Changing the pause after the recall key
P#Q5#12
¤
MENU
flashes: 1 = 800 ms; 2 = 1600 ms; 3 = 3200 ms
¢
page 15). If you have no problems with
¤
The number for the set dialling mode flashes:
¤
The number for the current recall flashes:
¤
.
enter number OK
¤
The number for the current pause length
¤
enter number
¤
The number for the current pause length
¤
enter number
¤ ¤
.
enter number OK
b
and
¤
.
OK
¤
.
OK