Technical Specifications; Warranty - Alcatel XL785 Voice Combo User Manual

14.

TECHNICAL SPECIFICATIONS

Free Field Range Up to 300 metres*
Indoor Range Up to 50 metres*
Handset Battery Life 10 hours talk time**
(average values) 100 hours standby**
Number of Handsets Up to 4
Intercom Mode Yes
Three-Way Conference Yes
(1 outside correspondent +
2 internal correspondents)
Electrical Connection/Base Main base adapter and charger:
Mains Adaptor/Charger Model No .: AT-337E-060045A or 1-CHEUA451-081
Input: 100-240 V / 50-60 Hz / 0.15 A Output:
6 V DC / 450 mA, 2.7 W
Use only the adapters provided with the phone.
Single-phase AC, excluding IT installations defined by the
standard EN62368-1.
Attention: The network voltage is classified as dangerous accord-
ing to the criteria of this standard.
Telephone Connection Appliance designed for connection to a TNV3 class (telecommu-
nications network voltage) analogue telephone line as defined by
the EN62368 standard.
Batteries AAA battery pack – 2.4 V – 300 mA
Only use the batteries supplied with the telephone.
Use any other type of battery presents a risk of explosion. Used
batteries must be disposed of in compliance with current environ-
mental protection regulations.
Operating Temperature From 5°C to 40°C
* Values may vary according to environment.
** Depending on initial battery charge.
15. TROUBLESHOOTING
If you have difficulty with your phone, please try the suggestions listed below.
Problem Cause
No dialing tone when pressing a. The connection cord of the base
station may not be plugged in.
key
b. The adapter cord may not be
plugged in correctly in the base
station.
c. The line may be busy, as anoth-
er handset may not be used.
When connected to a PBX, no Dialing prefix is needed.
and/or wrong connection after
dialing.
"OUT OF RANGE" is displayed. a. Base station may be out of
range.
b. Base station may not be con-
nected to mains.
The call does not work. Service may not be activated or
wrong operation or wrong setting
No display. Empty battery
Solutions
a. Check the connections. Unplug
and plug back in the mains.
Check that the telephone line cord
has been plugged into the base
station and the phone socket.
b. Check the base station plug
and the 220V plug (remove and
plug-in).
c. Wait until the line is unoccu-
pied.
Insert the dialing prefix.
a. Reduce the range.
b. Connect base station to mains.
Check your Subscription with
network
Recharge battery
26
Incoming calls are blocked (if you a. Check if BLOCK SET. is set to
did not intend to enable Call Block VIP OK or CONTACTS OK?
function) b. Check if BLOCK SET. is set
to ON and the incoming call in
blacklist?
Answering Machine
The unit does not record new The answering machine may be
messages. turned off.
The caller cannot leave a mes- a. The answering machine may be
sage. turned off.
b. Message memory may be full.
I cannot operate the answering a. You may be entering the wrong
machine remotely. remote access code.
b. You may be pressing the dial
keys too quickly.
c. The answering machine may be
turned off.
d. You may be Through a pulse
telephone.
While recording an outgoing mes- Probably a call is being received.
sage or listening to messages, the
unit rings and recording stops.
Please contact the technical support of the telephone service provider for further information.
16.

WARRANTY

Please carefully read the user guide included in this kit. The Alcatel XL785 Combo product is approved equip-
ment in accordance with European regulations, attested by the CE mark. The product you have just purchased
is a technological product, it must be handled with care.
Note: you have a legal warranty on this product in accordance with the applicable regulations on the sale of
consumer goods in the country where you made this purchase.
For any information relating to this legal warranty, please contact your dealer.
Without prejudice to the legal warranty from which the products benefit, ATLINKS guarantees that the product
appearing in this box complies with its technical specifications appearing in the user guide included in this box,
and this for a warranty period, counted from the date of purchase of the new Product, the date appearing on
your invoice or receipt showing the name of your reseller as proof, and equal to: Twenty four (24) months for
the telephone device, at the exclusion of consumables, accessories and batteries.
For any claim under this warranty during the warranty period, you must return the entire Product to your re-
seller, along with proof of purchase, consisting of the invoice or sales receipt issued by your reseller, indicating
the place of purchase and the number of the invoice or sales receipt issued by your reseller, indicating the place
of purchase and the serial number of the Product, following the appearance or discovery of the defect.
ATLINKS undertakes to repair any defective item due to a design, material or manufacturing defect, at its ex-
pense, or to replace it, at its expense, with an identical or at least equivalent item in terms of functionality and
performance.
If repair or replacement is impossible under normal commercial conditions, the Product will be refunded to you
or replaced by an equivalent Product.
To the maximum extent permitted by applicable law, the replacement product or component, which may be new
or reconditioned, is warranted for a period of ninety (90) days from the date of repair or until the end date of
the initial warranty period if the latter is greater than ninety (90) days, it being specified that any period of im-
mobilization of the Product of at least seven (7) days will be added to the duration of warranty remaining to run.
This guarantee does not apply in the following cases:
‒Installation or use not in accordance with the instructions in the user guide,
‒Poor connection or abnormal use of the Product, in particular with incompatible accessories, as indicated in
the user guide,
‒Product opened, modified or replaced using unapproved parts, serial number erased, illegible, damaged,
Normal wear and tear, including normal wear and tear of accessories, batteries and screens,
‒No compliance with the technical and safety standards in force in the geographical area of use,
‒Product having suffered a shock or a fall,
‒Product damaged by lightning, an electrical surge, a source of heat or radiation, water damage, exposure to
excessive ambient conditions or any other cause external to the product,
a.If so, set BLOCK SET. to OFF.
b.If so, clean up the number in
Blocklist in part 5.1.4.
Turn on the answering machine.
a. Turn on the answering machine.
b. Erase unnecessary messages.
a. If you forget the remote access
code, reset to the default settings.
b. Press each key firmly.
c. Turn on the answering machine.
d. Try again Through a touch tone
phone.
Answer the incoming call and try
again to record your outgoing
message later.
27