Alcatel Temporis 10 - Telephone Manual

INSTALLING THE DEVICE

Your Temporis 10 telephone comprises:

• a base and a handset,
• a telephone cord, Connect one end of the telephone cord (spiral part)
• an emergency numbers label.

Connect the other end of the line cord (spiral part) to the jack on the bottom of the handset. Connect the other end of the line cord to the wall telephone.

WALL MOUNTING THE DEVICE

• To install the telephone on the wall, run the line cord (straight part) through the 2 slots under the base (bottom).
• Drill two vertical holes in the wall, 83 mm apart.
  Insert the anchors then screw in wood screws (diameter: 3 mm, length: 25 mm) without tightening them. Secure the base to the screws pulling it downwards.
• On the base, pivot the round plastic part (with a flat screwdriver or small coin) so that the word "wall" can be read correctly.
  

The screws are not supplied in the package.

USING THE DEVICE

• Calling a correspondent
  Pick up the handset, wait for the tone and dial the number of the personyou want to talk to.
• Redialling the last number
  Pick up the handset to obtain a tone then press the key.
• Adjusting the ringing volume (2 levels) on the handset top side
  The ringing volume adjustment is by default set to the highest volume( ). You can reduce it by placing the cursor opposite ( ).
• Mute function
  During a conversation, if you don't want your correspondent to hear you.
  To resume the conversation and allow your correspondent to hear you, press the key once more.
• Ringing light
  When there is an incoming call, the light on the top of the handset comes on.

Note: When connected to a business telephone system (PABX), a red indicator light ( ) blinks to signal the presence of voicemail messages (only applicable for some PABX).

SETTING THE DEVICE PARAMETERS

• Tone/Pulse dialling
  By default, your telephone uses voice frequency ( ). If this is not suitable, you can switch to pulse dialling by setting (with the tip of a pen) to ( ) the cursor located on the lower side of the handset.
• Pause ( )
  This function is only used behind a PABX (to insert a pause, e.g. between the PABX outgoing prefix and the number to send on the line).
• Flash time
  The cursor on the upper side of the handset can be used to modify the flash time (values: 100, 300 or 600 ms).
  Position the cursor (with the tip of a pen) on the chosen value (behind a PABX: 100 ms – English public network: 100 ms).
  Then confirm the change by hanging up the handset on the base before making a new call.

WHAT TO DO IF

There is no tone

• Check that the line cord is correctly connected to the wall jack.
• Check that the cradle on the handset is not blocked.

The telephone doesn't ring

• Check that the ringer is not switched off (see ringer adjustment).

You cannot hear your correspondent

• Check that another extension on the installation is not being used at the same time.

TECHNICAL SPECIFICATIONS

• Telephone connection: Appliance designed for connection to an analogue telephone line class TRT3 (telecommunications network voltage) as defined by standard NF EN 60950.
• Caution, the network voltage is classified as a hazard according to the criteria of this standard.
• Operating temperature: from 5 to 40°C.

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Alcatel Temporis 10 - Telephone Manual