Husqvarna WRE 125 2011 Specifications - Operation - Maintenance page 79

BRAKE PADS REMOVAL
- Remove springs (1).
- Remove pins (2).
- Remove pads.
CAUTION!
Don't operate the brake lever or pedal
while removing the pads.
1
2
2
1
PADS WEAR
Inspect pads for wear.
Service limit " A" is: 3,8 mm (0.15 in.).
If service limit is exceeded, always replace the pads in
pairs.
ANTERIORE
1
ANTERIORE
POSTERIORE
PADS CLEANING
Be careful that no disc brake fluid or any oil gets on
brake pads or discs. Use a suitable degreaser to clean the
pads or discs to remove any traces of fluid or oil.
Replace the pads with new ones if they cannot be cleaned
satisfactorily.
PADS INSTALLATION
- Install new brake pads.
- Reassemble the two pins (2) and the springs (1).
WARNING!
Pump the brake lever or pedal until the
pads are against the discs.
The brake will not function on the first
application of the lever or pedal.
Do not attempt to ride the motorcycle
until the brake lever or pedal are fully
effective.
POSTERIORE
EN - 35