Husqvarna WRE 125 2011 Specifications - Operation - Maintenance page 67

THROTTLE CABLE ADJUSTMENT
The throttle cable may be adjusted using the adjuster
screw on the cable itself or the adjuster screw on the car-
burettor cover. To check for proper adjustment of throttle
cable, proceed as follows:
- move the rubber cap (1) aside;
- move transmission sheath to and fro to ensure a play
of approx. 1 mm;
- should play be greater than 1 mm (0.04 in.), loosen
lock nut (2) and register (3); should play less than 1
mm (0.04 in.), then tighten lock nut and register;
1
3
2
- if register (3) should not provide sufficient movement
to allow for correct adjustment, then adjust register
placed on carburetor.
There should be approx. 1 mm (0.04 in.) play on latter
register; otherwise, move the rubber cap (4) aside and,
after loosening the check nut (6), loosen or tighten the
adjuster screw (5) to reduce or increase free play.
WARNING*: Operation with damaged
throttle cable could result in an unsafe
riding condition.
4
5
ADJUSTING THE IDLE
Idling should be adjusted only when the engine is hot
and throttle is closed, as follows:
- turn idle adjusting screw (1) so as to increase rpm
(1500 rpm ± 100 rev) (turn clockwise to increase rpms,
counterclockwise to decrease rpm).
WARNING*: Exhaust gas contains poiso-
nous carbon monoxide gas. Never run
the engine in a closed area or in a con-
fined area.
1
EN - 23