Enter Times - Bunn Single SH BrewWISE DBC Installation And Operating Manual

PROGRAMMING THE BREWER (cont.)
SET PULSE BREW - ENTER TIMES
NOTE: The procedure to enter the PULSE BREW
function must be performed prior to following the
steps listed below.
1. Press and release YES. The display should now
read EASY PULSE SETUP.
2. Press and release NO. The display will read ENTER
TIMES?
3. Press YES to proceed. The display should now
read 1st ON TIME X:XX.
4. Using (-) and (+) set the amount of time the flow
of water into the funnel will be on.
5. When finished, press DONE. The display will now
read OFF TIMES: X:XX.
6. Using (-) and (+) set the amount of time the flow
of water into the funnel will be off.
7. When finished, press DONE. The display will now
read LAST ON: X.XX
8. Using (-) and (+) set the amount of time the water
will be on to complete the brew.
9. When finished, press DONE. The display will show
the three times just entered for that batch size. After
a 5 second delay, the display will read 3 BATCHES
DONE?
10. If other batch sizes need to be modified, press
NO.
12. Press a different batch size and repeat steps 3
through 7. Repeat until all the desired batch sizes
are set.
13. When finished press YES in 3 BATCHES DONE?.
The display will then read DRIP TIME.
14. Press and release the ON/OFF switch located on
the front switch panel to exit the SET PULSE BREW
function and return to the MAIN SCREEN.
NOTE: Pressing the upper right hidden switch before
reaching the final setting screen exits the setup and
retains the old values.
SET PULSE BREW?
NO
EASY PULSE SETUP
NO

ENTER TIMES?

NO
1st ON TIME X:XX
(-)
OFF TIMES: X:XX
(-)
LAST ON: X.XX
(-)
1st
XX.X
3 BATCHES DONE?
NO
Page 27
YES
YES
NEXT FUNCTION
YES
DONE (+)
DONE (+)
DONE (+)
OFF LAST
XX.X XX.X
5 SEC. DELAY
YES
NEXT FUNCTION
EXIT TO
SCREEN
EXIT TO
SCREEN
P3265
34025.2 071105