RF Burst Trigger Level
:TRIGger[:SEQuence]:RFBurst:LEVel <percent>
:TRIGger[:SEQuence]:RFBurst:LEVel?
Set the trigger level when using the RF Burst (wideband) Trigger. The
value is relative to the peak of the signal. RF Burst is also known as RF
Envelope.
Factory Preset
−6.0 dB
and *RST:
−25 to 0 dB
Range:
−200 to 0 dB, for NADC, PDC
Default Unit:
dB
Front Panel
Access:
Mode Setup
RF Burst Trigger Slope
:TRIGger[:SEQuence]:RFBurst:SLOPe POSitive|NEGative
:TRIGger[:SEQuence]:RFBurst:SLOPe?
Set the trigger slope when using the RF Burst (wideband) Trigger.
Factory Preset
and *RST:
Positive
Remarks:
You must be in the cdmaOne, cdma2000, W-CDMA
mode to use this command. Use :INSTrument:SELect
to set the mode.
Front Panel
Access:
Mode Setup, Trigger, RF Burst, Slope
Chapter 5
,
Trigger, RF Burst, Peak Level
Language Reference
TRIGger Subsystem
295