Installing Optional Measurement Personalities; Available Personality Options - Agilent Technologies E4406A VSA Series Programmer's Manual

Installing Optional
Measurement Personalities
When you Install a measurement personality, you follow a two step
process.
1. The measurement personality firmware must be installed into the
instrument. (See the supplied installation instructions.)
2. A license key number must be entered which enables the
measurement personality to run. (Refer to the "License Key
Numbers" section below.)
Adding additional measurement personalities requires purchasing a
retrofit kit for the desired option. The retrofit kit includes the
measurement personality firmware, usually supplied on a zip disk. The
license key certificate, included in the kit, contains the license key
number. Every retrofit kit will have installation instructions.
The installation instructions require you to know three pieces of
information about your instrument: the amount of memory installed,
the Host ID, and the instrument serial number.
Required information:
Instrument
Memory:
__________________
Host ID:
__________________
Instrument
Serial Number:
__________________
The Exit Main Firmware key is used during the firmware installation
process. This key is only for use when you want to update firmware
using a LAN connection. The
of the resident firmware code so you can install an updated version of
firmware using a LAN connection. Instructions for loading future
firmware updates are available at the following URL:
www.agilent.com/find/vsa/

Available Personality Options

The option designation consists of three characters, as shown in the
Chapter 1

Installing Optional Measurement Personalities

Key Path:
,
System File System
(the amount of memory in your
instrument will be the sum of the
memory and the
Free
, ,
System Show System Host ID
, ,
System Show System Serial Number
key halts the operation
Exit Main Firmware
Preparing for Use
Used
memory)
17