Replacing A Dry Ink/Toner Cartridge - Xerox Versant 2100 Press Quick Start Manual

Maintenance
e) Select the Technical Key Operator icon.
The Technical Key Operator feature displays.
f) Select the item (HCF) that corresponds with the newly-replaced components.
g) Select Reset Current Value. The system resets the HFSI to 0.
14. Exit administrator mode by pressing the Log In/Out button on the Control Panel.
When prompted, select Logout.

Replacing a Dry Ink/Toner Cartridge

Note
The dry ink/toner cartridge can be replaced while a job is printing.
Note
After you replace a dry ink/toner cartridge, the system automatically resets the HFSI
usuage counter for this CRU to zero (0). Check the Consumables Supplies screen to verify
the reset and new status.
1. Open the Dry Ink/Toner cover, located just above the press front door/cover.
2. Lay paper on the floor before removing the cartridge. This will allow any excess dry
ink/toner to fall on the paper.
3. Grasp the handle of the dry ink/toner cartridge matching the color indicated in the
message.
4. Remove the dry ink/toner cartridge by slowly and gently pulling it straight out. While
pulling out, hold the bottom of the cartridge with your other hand to give it support.
5. Dispose of or recycle the cartridge per your local authorities and regulations.
In the United States, also refer to the Electronic Industries Alliance website:
www.eiae.org. For more information about Xerox environmental programs, go to
www.xerox.com/environment.
5-10 Xerox ® Versant 2100 Press
Quick Start Guide