Brother DCP-8060 User Manual page 66

Error Message Cause
The duplex tray is not installed
Duplex
properly.
Disabled
(DCP-8065DN only)
The primary corona wire on the
Dust On Drum
drum unit needs to be cleaned.
The temperature of the fuser unit
Fuser Error
does not rise at a specified
temperature within a specified time.
The fuser unit is too hot.
The machine is out of paper or
No Paper
paper is not properly loaded in the
paper tray.
The paper tray is not completely
No Tray
closed.
The machine's memory is full.
Out of Memory
The paper is jammed in the back of
Paper Jam
the machine.
Back
The paper is jammed in the duplex
Paper Jam
tray.
Duplex
The paper is jammed inside the
Paper Jam
machine.
Inside
The paper is jammed in the MP tray
Paper Jam
of the machine.
MPTray
The paper is jammed in the paper
Paper Jam
tray of the machine.
Tray1
Paper Jam
Tray2
60
Action
Remove the duplex tray and install it again.
Clean the primary corona wire on the drum unit.
(See Cleaning the corona wire on page 71.)
Turn the power switch off, wait a few seconds,
and then turn it on again. Leave the machine for
15 minutes with the power on.
Do one of the following:
Refill the paper in the paper tray or MP tray.
Remove the paper and load it again.
Close the paper tray properly.
Copy operation in progress
Do one of the following:
Press Start to copy the scanned pages.
Press Stop/Exit and wait until the other
operations in progress finish, and then try
again.
Printing operation in process
Do one of the following:
Reduce print resolution. (See Advanced tab
in the Software User's Guide on the
CD-ROM.)
Turn on the Page Protection function. (See
Device Options in the Software User's Guide
on the CD-ROM.)
Clear the data from the memory by pressing
Job Cancel.
(See Paper jams on page 63.)
(See Paper jams on page 63.)
(See Paper jams on page 63.)
(See Paper jams on page 63.)
(See Paper jams on page 63.)