Exmark Radius X Series Operator's Manual page 53

Note: Ensure the oil filter gasket touches the
engine, then an extra 3/4 turn is completed.
Note: Dispose of the used oil at a recycling
center.
6. Slowly pour approximately 80% of the specified
oil into the filler tube—use oil recommended in
the Checking the Engine Oil Level section.
Figure 53
g027477
7. Check the oil level; refer to Checking the
Engine Oil Level section.
8. Start the engine and check for leaks.
Servicing the Spark Plug
Service Interval: Every 100 hours/Yearly
Ensure that the air gap between the center and side
electrodes is correct before installing the spark plug.
Use a spark plug wrench for removing and installing
the spark plug and a gapping tool or feeler gauge to
check and adjust the air gap. Install a new spark plug
if necessary.
Type: Champion RN9YC or equivalent
Air Gap: 0.030 inch (.76 mm)
53
Maintenance
Figure 54
(whichever comes
first)—Check the spark
plug (Exmark engine).
Every 200 hours/Every 2
years (whichever comes
first)—Replace the spark
plug (Exmark engine).
g027484