Exmark Radius X Series Operator's Manual page 32

Operation
Knowing this information could help you, your
family, pets, or bystanders avoid injury.
To transport the machine:
• Lock the brake and block the wheels.
• Be sure the fuel shut-off valve is closed.
• Securely fasten the machine to the trailer or
truck with straps, chains, cable, or ropes. Only
use the four designated tie-down locations on
the mower–two on the left side and two on the
right (see Figure 21). Use these locations even
when transporting the mower with an attached
accessory. Using non-designated locations may
cause damage to the mower and/or attachment.
Figure 21
Right side shown
1. Tie-down location
• Secure a trailer to the towing vehicle with safety
chains.
WARNING
Driving on the street or roadway without turn
signals, lights, reflective markings, or a slow
moving vehicle emblem is dangerous and can
lead to accidents causing personal injury.
Do not drive machine on a public street or
roadway.
Loading the Machine
Use extreme caution when loading or unloading
machines onto a trailer or a truck. Use a full-width
ramp that is wider than the machine for this
procedure. Back up ramps and drive forward down
ramps (Figure 22).
1. Back up ramps
Important: Do not use narrow individual ramps
for each side of the machine.
Ensure the ramp is long enough so that the angle with
the ground does not exceed 15 degrees (Figure 23).
On flat ground, this requires a ramp to be at least four
times (4X) as long as the height of the trailer or truck
bed to the ground. A steeper angle may cause mower
components to get caught as the unit moves from the
ramp to the trailer or truck. Steeper angles may also
cause the machine to tip or lose control. If loading on
or near a slope, position the trailer or truck so that it
is on the down side of the slope and the ramp extends
up the slope. This will minimize the ramp angle.
g037521
32
Figure 22
2. Drive forward down
ramps
g028043