Exmark Radius X Series Operator's Manual page 50

Maintenance
4. Separate the foam and paper elements.
Cleaning the Foam and Paper Elements:
Foam Element:
Wash the foam element with water.
Important: Replace the foam element if it is
torn or worn.
Paper Element:
1. Lightly tap the element on a flat surface to remove
dust and dirt.
2. Inspect the element for tears, an oily film, and
damage to the seal.
Important: Do not clean the paper element
with pressurized air or liquids, such as
solvent, gas, or kerosene. Replace the paper
element if it is damaged or cannot be cleaned
thoroughly.
Figure 46
Figure 47
To learn more about the Exmark twin-cylinder engine
go to https://exmark.com/engines or scan the QR
code.
Checking the Engine Oil Level
g027801
Service Interval: Before each use or daily
Important: Do not overfill the crankcase with oil
and run the engine; engine damage may result.
1. Park the machine on a level surface, disengage
the blade control switch, stop the engine, engage
parking brake, and remove the key.
2. Make sure the engine is stopped, level, and is cool
so the oil has had time to drain into the sump.
3. To keep dirt, grass clippings, etc., out of
the engine, clean the area around the oil fill
cap/dipstick before removing it.
g027802
4. Check the engine oil level.
50
Figure 48
Exmark Engine
g028322