Specifications; Systems - Exmark Radius X Series Operator's Manual

Specifications

Systems

Engine
• Engine Specifications: See your Engine Owner's
Manual
• Engine Oil Type: Exmark 4–Cycle Premium
Engine Oil
• RPM:
– X-Series: Full Speed: 3750 ±50 RPM (PTO
not engaged) Idle: 1500 ±100 RPM
– S-Series: Full Speed: 3600 ±50 RPM (PTO
not engaged) Idle: 1500 ±100 RPM
– E-Series with Exmark Engines: Full Speed:
3600 ±50 RPM (PTO not engaged) Idle: 1500
±100 RPM
– E-Series with Kohler Engines: Full Speed:
3750 ±50 RPM (PTO not engaged) Idle: 1500
±100 RPM
Fuel System
• Capacity: 7.0 gal. (26.5 L)
• Fuel Recommendations:
– For best results, use only clean, fresh, unleaded
gasoline with an octane rating of 87 or higher
((R+M)/2 rating method).
– Oxygenated fuel with up to 10% ethanol or
15% MTBE by volume is acceptable.
– Do Not use ethanol blends of gasoline (such
as E15 or E85) with more than 10% ethanol
by volume. Performance problems and/or
engine damage may result which may not be
covered under warranty.
– Do Not use gasoline containing methanol.
– Do Not store fuel either in the fuel tank or
fuel containers over the winter unless a fuel
stabilizer is used.
– Do Not add oil to gasoline.
• Fuel Filter: Replaceable In-line
• Fuel Shut-Off Valve:
All Units: 1/4 turn ("ON", "OFF").
Electrical System
• Charging System: Flywheel Alternator
• Charging Capacity: 15 amps
• Battery Type: BCI Group U1
• Recommended Minimum Battery CCA: 260 CCA
• Battery Voltage: 12 Volt
• Polarity: Negative Ground
• Fuses:
All units:
– 20 amp charging system fuse
(not used on Kohler engines)
– 15 amp main fuse
Safety Interlock System
• LCD indicators appear for the PTO, park brake,
drive levers, and operator presence in the message
display on the RH control panel.
• PTO must be disengaged, brake engaged, and
motion control levers out (neutral lock) to start
engine. (It is not necessary for the operator to be
in the seat to start the engine.)
• Operator must be in seat when PTO is engaged,
brake is disengaged, or motion control levers are
moved in or engine will stop.
• Engine will stop if either the left, the right, or
both levers are moved from neutral lock position
while brake is engaged.
Operator Controls
• Steering and Motion Control:
Note: Motion control levers are adjustable to
three heights.
– Separate levers, on each side of the console,
control speed and direction of travel of the
respective drive wheels.
– Steering is controlled by varying the position
of the levers relative to each other.
– Moving motion control levers outward (in
slots) locks the drive system in neutral.
• PTO Engagement Switch: Engages electric clutch
(to drive belt) which engages mower blades.
• Parking Brake Lever: Engages parking brake.
• Deck Height Adjustment Lever: Sets cutting
height to desired position.
13
Specifications