Table of Contents
Advertisement
Step 4 : Detach 2P wire at the connector (CN106) on Main
P.C.B..
Step 5 : Detach 7P wire at the connector (CN901) on Main
P.C.B..
Step 6 : Detach 9P wire at the connector (CN900) on Main
P.C.B..
Step 7 : Release 2 catches.
Step 8 : Remove Main P.C.B. as shown.
Caution : Ensure the Main P.C.B. unit is insert into the hole
of Rear Cabinet Assembly as shown. Check Aux Jack
(JK951) & Headphone Jack (JK952).
Caution : During assembling, ensure the Main P.C.B. is
fully catched & properly seated onto the locator.
70
Advertisement
Table of Contents
