Operating Instructions
Compact Stereo System
SC-HC25
Model No.
Dear Customer
SUPPLIED ACCESSORIES
Thank you for purchasing this system.
Please check and identify the supplied accessories.
For optimum performance and safety, read
these instructions fully before you connect,
1 x AC mains lead
1 x Remote control
operate or adjust this system.
(N2QAYB000640)
Keep this manual for future reference.
1 x FM indoor antenna
1 x Remote control
Your system and the illustrations can look
1 x AM loop antenna
battery
differently.
Do the procedures with the remote
control. You can also use the buttons
on the main unit if they are the same.
Panasonic Corporation
Web Site: http://panasonic.net
RQTX1256-B
Bottom of product
Inside of product
WARNING:
CAUTION!
TO REDUCE THE RISK OF FIRE, ELECTRIC
THIS PRODUCT UTILIZES A LASER.
SHOCK OR PRODUCT DAMAGE,
USE OF CONTROLS OR ADJUSTMENTS
• DO NOT EXPOSE THIS APPARATUS
OR PERFORMANCE OF PROCEDURES
TO RAIN, MOISTURE, DRIPPING OR
OTHER THAN THOSE SPECIFIED HEREIN
SPLASHING AND THAT NO OBJECTS
MAY RESULT IN HAZARDOUS RADIATION
FILLED WITH LIQUIDS, SUCH AS VASES,
EXPOSURE.
SHALL BE PLACED ON THE APPARATUS.
DO NOT OPEN COVERS AND DO NOT REPAIR
• USE ONLY THE RECOMMENDED
YOURSELF. REFER SERVICING TO QUALIFIED
PERSONNEL.
ACCESSORIES.
• DO NOT REMOVE THE COVER (OR BACK);
THERE ARE NO USER SERVICEABLE
PARTS INSIDE. REFER SERVICING TO
THIS UNIT IS INTENDED FOR USE IN
QUALIFIED SERVICE PERSONNEL.
MODERATE CLIMATES.
CAUTION!
The socket outlet shall be installed near the
• DO NOT INSTALL OR PLACE THIS UNIT IN
equipment and easily accessible.
A BOOKCASE, BUILT-IN CABINET OR IN
The mains plug of the power supply cord shall
ANOTHER CONFINED SPACE. ENSURE
remain readily operable.
THE UNIT IS WELL VENTILATED. TO
To completely disconnect this apparatus from the
PREVENT RISK OF ELECTRIC SHOCK OR
AC Mains, disconnect the power supply cord plug
FIRE HAZARD DUE TO OVERHEATING,
from AC receptacle.
ENSURE THAT CURTAINS AND ANY OTHER
MATERIALS DO NOT OBSTRUCT THE
VENTILATION VENTS.
This product may receive radio interference
• DO NOT OBSTRUCT THE UNIT'S
caused by mobile telephones during use. If
VENTILATION OPENINGS WITH
such interference is apparent, please increase
NEWSPAPERS, TABLECLOTHS, CURTAINS,
separation between the product and the mobile
AND SIMILAR ITEMS.
telephone.
• DO NOT PLACE SOURCES OF NAKED
FLAMES, SUCH AS LIGHTED CANDLES, ON
THE UNIT.
• DISPOSE OF BATTERIES IN AN
Product identification marking is located on the
ENVIRONMENTALLY FRIENDLY MANNER.
bottom of unit.
SAFETY PRECAUTIONS
Placement
Foreign matter
Set the system up on an even surface away from
Do not let metal objects fall inside the system. This
direct sunlight, high temperatures, high humidity,
can cause electric shock or malfunction.
and excessive vibration. These conditions can
Do not let liquids get into the system. This can
damage the cabinet and other components, thereby
cause electric shock or malfunction. If this occurs,
shortening the service life of the system.
immediately disconnect the system from the power
Place it at least 15 cm away from wall surfaces to
supply and contact your dealer.
avoid distortion and unwanted acoustical effects.
Do not spray insecticides onto or into the system.
Do not place heavy items on the system.
They contain flammable gases which can ignite if
sprayed into the system.
Voltage
Service
Do not use high voltage power sources. This can
overload the system and cause a fire.
Do not attempt to repair this system by yourself.
If sound is interrupted, indicators fail to light,
Do not use a DC power source. Check the source
smoke appears, or any other problem that is not
carefully when setting the system up on a ship or
covered in these instructions occurs, disconnect
other place where DC is used.
the AC mains lead and contact your dealer or an
authorised service centre. Electric shock or damage
AC mains lead protection
to the system can occur if the system is repaired,
disassembled or reconstructed by unqualified
persons.
Ensure the AC mains lead is connected correctly
and not damaged. Poor connection and lead
Extend operating life by disconnecting the system
damage can cause fire or electric shock. Do not
from the power source if it is not to be used for a
pull, bend, or place heavy items on the lead.
long time.
Grasp the plug firmly when unplugging the lead.
Pulling the AC mains lead can cause electric shock.
Do not handle the plug with wet hands. This can
cause electric shock.
MAINTENANCE
To clean this system, wipe with a soft, dry cloth.
• Never use alcohol, paint thinner or benzine to clean this system.
• Before using chemically treated cloth, read the instructions that came with the cloth carefully.
GN
En
L0111CH0
"Made for iPod" and "Made for iPhone" mean that an electronic accessory has been designed to connect
specifically to iPod, or iPhone, respectively, and has been certified by the developer to meet Apple
performance standards.
Apple is not responsible for the operation of this device or its compliance with safety and regulatory
standards.
Please note that the use of this accessory with iPod, or iPhone may affect wireless performance.
iPhone, iPod, iPod classic, iPod nano, and iPod touch are trademarks of Apple Inc., registered in the U.S.
and other countries.
MPEG Layer-3 audio coding technology licensed from Fraunhofer IIS and Thomson.
– If you see this symbol –
Information on Disposal in other Countries outside the European Union
This symbol is only valid in the European Union.
If you wish to discard this product, please contact your local authorities or dealer and ask for
the correct method of disposal.
SPECIFICATIONS
Amplifier section
USB section
RMS output power stereo mode
USB port
USB Standard
USB 2.0 full speed
Front Ch (both ch driven)
5 W per channel (6 ), 1 kHz, 10% THD
Media file format support
Total RMS stereo mode power
10 W
USB device file system
FAT 12, FAT 16, FAT 32
USB port power
FM/AM tuner, terminals section
Speaker section
Preset station
FM 30 stations
AM 15 stations
Type
1 way, 1 speaker system (bass reflex)
Speaker unit(s)
Frequency modulation (FM)
Full range
Frequency range
87.50 MHz to 108.00 MHz (50 kHz step)
Impedance
Antenna terminals
75
(unbalanced)
Frequency range
60 Hz to 25 kHz (–16 dB)
Amplitude modulation (AM)
90 Hz to 22 kHz (–10 dB)
Frequency range
522 kHz to 1629 kHz (9 kHz step)
General
520 kHz to 1630 kHz (10 kHz step)
Headphones jack
Power supply
AC 220 to 240 V, 50 Hz
Terminal
Stereo, 3.5 mm jack
Power consumption
AUX (rear)
Dimensions (W x H x D)
Terminal
Stereo, 3.5 mm jack
400 mm x 221 mm x 110 mm
[D = 69 mm (min)]
Disc section
[D = 149 mm (tray open)]
Mass
Operating temperature range
Disc played (8 cm or 12 cm)
CD, CD-R/RW (CD-DA, MP3 formatted disc)
Operating humidity range
MPEG-1 Layer 3, MPEG-2 Layer 3
35% to 80% RH (no condensation)
Pick up
Power consumption in standby mode
Wavelength
790 nm (CD)
0.2 W (approximate)
Laser power
CLASS 1 (CD)
Audio output (Disc)
Note:
1) Specifications are subject to change without notice.
Number of channels
2 ch (FL, FR)
Mass and dimensions are approximate.
FL = Front left channel
2) Total harmonic distortion is measured by the digital
FR = Front right channel
spectrum analyzer.
3
OVERVIEW OF CONTROLS
Refer to the numbers in parentheses for
chapter references.
A Standby/on switch [`], [1] (7, 11)
Press to switch the unit from on to standby
SLEEP
PLAY
I
A
mode or vice versa. In standby mode, the
unit is still consuming a small amount of
power.
J
B Numeric buttons [1 to 9, 0, ≧10]
B
To select a 2-digit number
Example: 16: [≧10] → [1] → [6]
K
C Delete a programmed track (4)
C
L
D Select source
[iPod]: Select iPod (5)
EXT-IN
D
RADIO
[CD]: Select disc (4)
[RADIO, EXT-IN]: Select radio, USB or
AUX (6, 9)
E
E Basic operation
[4/9]: Playback or pause operation
[8]: Stop playback
[2], [6]: Skip track
SOUND
D.BASS
PRESET EQ
Select preset radio station
F
[3], [5]: Search track
Tune in to the radio station
M
[2/3], [5/6]: Skip and search
track
G
N
Select preset
radio station
O
DISPLAY
F Select the sound effects (8)
DIMMER
AUTO OFF
G Select the iPod menu item (5)
H
P
H View the information shown on the display
panel.
Decrease the brightness of the display
panel
Press and hold the button to use this
function.
To cancel, press and hold the button again.
I Set the sleep timer (7)
Set the clock and timer (7)
J Set the program function (4, 6)
1
MAKING THE CONNECTIONS
Conserving power
2
Connect the AM loop antenna.
The system consumes approximately 0.2 W when it
is in standby mode. Disconnect the power supply if
you do not use the system.
Some settings will be lost after you disconnect the
MP3 ( .mp3)
system. You have to set them again.
500 mA (max)
3
Connect the AC mains lead.
Use the included AC mains lead with this system
8 cm cone type
only.
Do not use an AC mains lead from other
6
equipment.
1
Connect the FM indoor antenna.
Place the antenna where reception is best.
Note:
• These speakers do not have magnetic shielding. Do
Adhesive tape
not put them near TVs, PCs or other equipment easily
influenced by magnetism.
• You cannot remove the net of the speakers.
19 W
2
2.1 kg
PREPARING THE REMOTE CONTROL
0°C to +40°C
CAUTION!
• Do not break open or short-circuit the battery.
• Do not charge the alkaline or manganese battery.
• Do not use the battery if the cover has peeled off.
• Do not heat or expose to flame.
• Do not leave the battery(ies) in an automobile
exposed to direct sunlight for a long period of time
with doors and windows closed.
• Mishandling of battery can cause electrolyte leakage,
which can cause a fire.
• Remove the battery if you do not use the remote
control for a long period of time. Keep in a cool, dark
area.
Use alkaline or manganese battery.
Install the battery so that the poles (+ and –) align
CAUTION!
with those in the remote control.
Danger of explosion if battery is incorrectly
replaced. Replace only with the same
Point the remote control at the remote control
or equivalent type recommended by the
sensor, away from obstacles, at a maximum range
manufacturer. Dispose of used batteries
of 7 m directly in front of the main unit.
according to the manufacturer's instructions.
K Adjust the volume of the system
L Mute the sound of the system
Press the button again to cancel.
"MUTE" is also cancelled when you adjust
the volume or when you switch off the
system.
M Set the play menu item (4)
Top view
N Set the radio menu item (6)
Q
R
O [R, T]: Skip album
Adjust clock setting
S
[Y, U]: Select the item in the menu
[OK]: Confirm the setting
P Automatically switch off the system
This function switches off the system
(except in radio source) if you do not use
the system for approximately 30 minutes.
A
To cancel, press the button two times.
D
Q Headphones jack ( )
Plug type: Ø 3.5 mm stereo (not included)
• Avoid listening for prolonged periods of
U
time to prevent hearing damage.
• Excessive sound pressure from
Front view
earphones and headphones can cause
hearing loss.
• Listening at full volume for long periods
may damage the user's ears. Be sure
to use the supplied or recommended
headphones or earphones.
R AUX jack
S USB port (
)
T Open or close the sliding door
U Display panel
V Sliding door
W Remote control sensor
X Open or close the iPod or iPhone dock
Click!
T
K
E
V
W
X