Adjusting the Airflow Rate
NOTE
■
Notes on airflow direction setting
•
The movable range of the flaps varies according to the operation modde.
■
Note on the angles of the fl aps
•
Using 3-D airflow circulates cold air, which tends to collect at the bottom of the room, and hot air, which tends to collect near the ceiling,
through out the room, pr
■
Note on airfl ow rate setting
•
At smaller airflow rates, the cooling (heating) effect is also smaller.
13
You can adjust the airflow rate to increase your comfort.
■
To adjust the airfl ow rate setting
Press
• Each pressing of
Auto
•
When the airflow is set to "
from the unit will become quiete
•
In indoor unit quiet operation, the airflow rate is set to a weak level.
•
If the temperature dose not reach the desired point, change the airflow rate setting.
•
In DRY mode, the airflow rate setting is not available.
eventing areas of cold and hot developing.
.
change the airflow rate setting in sequence shown below.
Indoor unit quiet
Low
High
Middle high
", indoor unit quiet ope
r.
Movable range of the flap
Middle low
Middle
ration will start and the noise
COOL / DRY
FAN ONLY
HEAT