Preparation Before Operation - Daikin FTHF40RVLT Operation Manual

Preparation before Operation

1
3
2
Position and
correctly!
Remote controller
Remote
Screws
controller
holder
NOTE
■
Notes on batteries
• When replacing the batteries, use batteries of the same type, and replace both old batteries together.
• When
the system is not used for a long time, take the batteries off.
• The batteries will last for approx. 1 year. If the remote controller display begins to fade and the degradation of reception performance occurs
within a year, however, replace both batteries with new, size AAA.LR03 (alkaline).
• The attached batteries are provided for the initial use of the system.
The usable period of the batteries may be short depending on the manufactured date of the air conditioner.
■
Low batteries alert
• To prevent remote controller from deteriorate batteries. When batteries seem to be dying (battery voltage lower).
The LCD will blink and the remote controller will stop all operations except to turn off the air conditioner.
To operate remote controller again, replace all the batteries with the new, size AAA. LR03 (Alkaline).
■
Notes on remote controller
• Never expose the remote controller to direct sunlight.
• Dust on the signal transmitter or receiver will reduce the sensitivity. Wipe off dust with soft cloth.
• Signal communication may be disabled if an electronic-starter-type fluorescent lamp (such as inverter-type lamps) is in the room. Consult the
shop if that is the case.
• If the remote controller signals happen to operate another appliance, move that appliance to somewhere else, or consult the service shop.
9
■
To set the batteries
1.
Slide the back cover to take it off.
2.
Set two dry batteries AAA.LR03 (alkaline).
3.
Set the back cover as before.
■
To fix the remote controller holder on the wall
1.
Choose a place from where the signals can
reach the unit.
2.
Fix the holder to a wall, a pillar, or similar
location with the scr
accessory set.
3.
Place the remote controller in the remote
controller holder.
■
Turn the breaker on
• After the power is turned on, the flaps of the indoor unit opens and closes once to set
the re ference position.
ews supplied with the