Table of Contents
Advertisement
4.1 USER INTERFACE
Clock/Timer
setting button
Select mode
button
4.2 OPERATION
4.2.1 Power 'ON'
When turning 'ON' the power, the whole icons will be displayed on the
controller screen for 3 seconds. After checking if everything is ok, the unit
enters into standby mode. Water temperature value and clock time are
displayed on the screen.
4.2.2 ON/OFF button
In standby mode if you press this button for 3 seconds, the unit will start
operation in accordance with the setting mode. The running mode, set
temperature and water temperature, clock time and timer situation will be
displayed on the screen.
When the unit is in operation and if you press this button for about 3 seconds,
it will enter in standby mode. Press the same button to exit from parameters
reading mode or to check the status of the unit.
4.2.3 UP
and DOWN
These are multi-function buttons. They are used for setting of temperature, parameters, and for clock and timer
adjustments.
30
Up and down buttons
buttons
ON/OFF button
(unit)
Advertisement
Table of Contents
