ZyXEL Communications LTE7461-M602 User Manual page 90

Lte outdoor router
Hide thumbs Also See for LTE7461-M602:
Table of Contents

Advertisement

Figure 65 Routing: Add New Static Route
The following table describes the labels in this screen.
Table 27 Routing: Add/Edit
LABEL
DESCRIPTION
Active
Activates static route.
Route Name
Assign a name for your static route (up to 15 characters). Special characters are allowed
except the following: double quote (") back quote (`) apostrophe or single quote (') less than
(<) greater than (>) caret or circumflex accent (^) dollar sign ($) vertical bar (|) ampersand (&)
semicolon (;)
IP Type
Select between IPv4 or IPv6. Compared to IPv4, IPv6 (Internet Protocol version 6), is designed to
enhance IP address size and features. The increase in IPv6 address size to 128 bits (from the 32-
bit IPv4 address) allows up to 3.4 x 1038 IP addresses. The Zyxel Device can use IPv4/IPv6 dual
stack to connect to IPv4 and IPv6 networks, and supports IPv6 rapid deployment (6RD).
Destination IP
This parameter specifies the IP network address of the final destination. Routing is always based
Address
on network number. If you need to specify a route to a single host, use a subnet mask of
255.255.255.255 in the subnet mask field to force the network number to be identical to the host
ID.
IP Subnet Mask
Enter the IP subnet mask here.
Use Gateway IP
Enables forwarding packets to a gateway IP address or a bound interface.
Address
Gateway IP
You can decide if you want to forward packets to a gateway IP address or a bound interface.
Address
If you want to configure Gateway IP Address, enter the IP address of the next-hop gateway. The
gateway is a router or switch on the same network segment as the Zyxel Device's LAN or WAN
port. The gateway helps forward packets to their destinations.
Use Interface
You can decide if you want to forward packets to a gateway IP address (Default) or a bound
interface (Cellular WAN).
If you want to configure bound interface, choose an interface through which the traffic is sent.
You must have the WAN interfaces already configured in the Broadband screen.
Chapter 8 Routing
LTE7461-M602 User's Guide
89

Advertisement

Table of Contents
loading

Table of Contents