ZyXEL Communications LTE7461-M602 User Manual page 60

When you use the PIN method, you must enter the PIN from one device (usually the WiFi client) into the
second device (usually the Access Point or wireless router). Then, when WPS is activated on the first
device, it presents its PIN to the second device. If the PIN matches, one device sends the network and
security information to the other, allowing it to join the network.
Take the following steps to set up a WPS connection between an access point or wireless router
(referred to here as the AP) and a client device using the PIN method.
Ensure WPS is enabled on both devices.
1
Access the WPS section of the AP's configuration interface. See the device's User's Guide on how to do
2
this.
Look for the client's WPS PIN; it will be displayed either on the device, or in the WPS section of the client's
3
configuration interface (see the device's User's Guide on how to find the WPS PIN - for the Zyxel Device,
see Section 6.4 on page
Enter the client's PIN in the AP's configuration interface.
4
If the client device's configuration interface has an area for entering another device's PIN, you can
5
either enter the client's PIN in the AP, or enter the AP's PIN in the client - it does not matter which.
Start WPS on both devices within two minutes.
6
Use the configuration utility to activate WPS, not the push-button on the device itself.
7
On a computer connected to the WiFi client, try to connect to the Internet. If you can connect, WPS
8
was successful.
If you cannot connect, check the list of associated WiFi clients in the AP's configuration utility. If you see
the WiFi client in the list, WPS was successful.
The following figure shows a WPS-enabled WiFi client (installed in a notebook computer) connecting to
the WPS-enabled AP via the PIN method.
Chapter 6 Wireless
48).
LTE7461-M602 User's Guide
59