The Wmm Screen - ZyXEL Communications LTE7461-M602 User Manual

The following table describes the labels in this screen.
Table 17 Network Setting > Wireless > WPS
LABEL
General
WPS
Add a new device with WPS Method
Method 1 PBC
WPS
Method 2 PIN
Register
Method 3
Release
Configuration
Generate
New PIN
Cancel
Apply

6.5 The WMM Screen

Enable Wi-Fi MultiMedia (WMM) and WMM Automatic Power Save (APSD) in WiFi networks for delay-
sensitive multimedia applications. WMM enhances data transmission quality which allows delay-sensitive
applications, such as videos, to run more smoothly. APSD improves power management of WiFi mobile
clients. APSD works only if the WiFi device to which the Zyxel Device is connected also supports this
feature.
Click Network Setting > Wireless > WMM to display the following screen.
Chapter 6 Wireless
DESCRIPTION
Click to enable ( ) and have the Zyxel Device activate WPS. Otherwise, it is disabled.
Use this section to set up a WPS WiFi network using Push Button Configuration (PBC). Click this
switch to make it turn blue. Click Apply to activate WPS method 1 on the Zyxel Device.
Click this button to add another WPS-enabled WiFi device (within WiFi range of the Zyxel
Device) to your WiFi network. This button may either be a physical button on the outside of a
device, or a menu button similar to the WPS button on this screen.
Note: You must press the other WiFi device's WPS button within two minutes of
pressing this button.
Use this section to set up a WPS
Device. Click this switch to make it turn blue. Click Apply to activate WPS method 2 on the Zyxel
Device.
Enter the PIN of the device that you are setting up a WPS connection with and click
authenticate and add the WiFi device to your WiFi network.
You can find the PIN either on the outside of the device, or by checking the device's settings.
Note: You must also activate WPS on that device within two minutes to have it
present its PIN to the Zyxel Device.
Use this section to set up a WPS WiFi network by entering the PIN of the Zyxel Device into the
client. Click this switch to make it turn blue. Click Apply to activate WPS method 3 on the Zyxel
Device.
The default WPS status is configured.
Click this button to remove all configured WiFi and WiFi security settings for WPS connections on
the Zyxel Device.
If this method has been enabled, the PIN (Personal Identification Number) of the Zyxel Device is
shown here. Enter this PIN in the configuration utility of the device you want to connect to using
WPS.
The PIN is not necessary when you use the WPS push-button method.
Click the Generate New PIN button to have the Zyxel Device create a new PIN.
Click Cancel to restore your previously saved settings.
Click Apply to save your changes.
LTE7461-M602 User's Guide
WiFi
network by entering the PIN of the client into the Zyxel
49
Register to