Bosch Solution 6+6 Wireless AE Quick Reference Manual page 3

Solution 6+6 Wireless - AE
Introduction
Thankyou for choosing the
you will find this control panel extremely flexible, reliable and easy to use.
Before using the control panel for the first time, we suggest that you read the section in this Quick Reference Guide called
"Programming Using The Codepad" to familiarise yourself with the basic programming methodology.
The Quick Reference Guide is supplied with the control panel to provide installers with enough basic information to wire,
configure and operate the control panel. Due to the control panels many programmable features and options, we suggest
that you obtain the complete Installation Manual which provides detailed information on all system options and functions
as well as detailed information on the numerous programming methods.
Programming
The programming options of this control panel are stored in a non volatile EPROM. This memory will hold all the relevant
configuration and user specific data even during a total power loss.
The data retention time is as long as ten years without power, therefore no reprogramming will be required after powering
the control panel down.
The data can be altered as many times as required without the need for any additional specialised equipment. This memory
is laid out in numerous locations each of which holds the data for a specific function.
In general, the entire programming sequence will consist of nominating the location number and then entering or altering
the required data. You will repeat this procedure until all the data has been altered to suit your requirements. The factory
default settings have been selected for the control panel to report in Contact ID Format.
Note:
There are two programming modes. The Installer's Programming Mode and the Operators Programming Mode. Both
programming modes have individual access codes and these two codes must always be programmed differently. The
Master Code, as well as being able to arm and disarm the system gives access to the Operators Programming Mode. The
Installer's Code only gives access to the Installer's Programming Mode and does NOT arm and disarm the system.
Programming of the
Solution 6+6 Wireless - AE
methods.
Note: For further information on the different programming options available for the Solution
Wireless - AE control panel, refer to the Installation Manual (MA660I).
Quick Reference Guide
Solution 6+6 Wireless - AE
'15' is the maximum value that can be programmed into any location.
Remote Codepad
Hand Held Programmer (CC814)
Programming Key (CC891)
Alarm Link Upload/Download Software (CC816)
Bosch Security Systems Pty Limited
control panel for your installation. We are sure that
control panel can be carried out via any of the following four
ISSUE 1.00
6+6
Page 3