Bosch Solution 6+6 Wireless AE Quick Reference Manual page 4

Solution 6+6 Wireless - AE
Programming Using The Remote Codepad
The control panel must be in a disarmed state with no flashing zone alarm memories to access Installer's Programming
Mode. This can be achieved by entering the
2580
Code is . If the control panel has become armed in the
by the button again to disarm the control panel.
To access the Installer's Programming Mode, enter the four digit
factory default Installer Code is
flash simultaneously. If a long beep is heard, check the control panel for alarm memory. The combination of the
and ZONE indicators will indicate the data stored in the first location of the Primary Telephone Number (LOCATION
000).
Data Zone 1
Value LED
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Example
To move to a particular programming location, enter the location number required followed by the
data of the new location will now be displayed.
To move to the next location, press the
will be displayed via the zone LED indicators.
If you press the button without previously entering a location number, the system will step back one location. To
change data in the current location, enter the new value followed by the
the location and still leave you still positioned at the same location.
To proceed to the next location, press the
To exit the Installer's Programming Mode, enter the command
be heard and the system will return to normal.
For a more detailed explanation, refer to the
Note: The valid address range for a
Page 4
Quick Reference Guide
1234
. Three beeps will be heard and both the
Zone 2 Zone 3 Zone 4
LED LED LED
Zone Indicators When Programming
button. This will step you to the next location and the data in that location
button. The next locations data will now be displayed.
Installation Manual (MA660I)
Solution 6+6 Wireless - AE
Bosch Security Systems Pty Limited
followed by the button. The factory default Master
mode, simply enter the
AWAY
followed by the
AWAY
Zone 5 Zone 6 Zone 7
LED LED LED
button. This will store the new data into
960
followed by the
Solution 6+6 Wireless - AE
control panel is 000 to 213.
ISSUE 1.00
followed
button. The
and the STAY indicators will
MAINS
Zone 8 Mains
LED LED
button. The
button. Two beeps will