Troubleshooting - Bissell CleanView 3003 Series User Manual

Troubleshooting

WARNING
To reduce the risk of electric shock, turn power OFF and disconnect polarized plug from electrical outlet before performing maintenance or
troubleshooting checks.
Problem Possible causes
Vacuum Power cord not plugged in
cleaner won't
Blown fuse/tripped breaker
turn ON
Hose not attached to suction
opening
Crack or hole in hose
Vacuum
cleaner
Clog in vacuum
won't pick
up dirt
Dirt Tank full
and/or tools
are not
Dirt Tank or upper tank not
working
installed properly
Filters are dirty
Full Dirt Tank
Weakened
suction power
Dusty filter(s)
Power cord The power cord may pile on one
will not
side of the coiler
rewind
Power cord
Power cord may be twisted
won't pull out
Dirt Tank full
Visible dirt
escaping from
Filters missing or installed
cleaner
incorrectly
10
www.BISSELL.ca
Remedies
Check electrical plug
Check/replace fuse or reset breaker
Grasp the hose wand and firmly push
into the hose wand base
Check hose and replace if needed
Follow instructions on page 9 for
clearing clogs
Empty Dirt Tank
Position correctly and lock in place
Check and clean or replace Dirt Tank
and post-motor filters, see page 8
Empty Dirt Tank
Check, clean or replace filters
Pull out a large section of the cord
and rewind it
Press the rewind button and pull out
Empty Dirt Tank
Check Dirt Tank and post-motor
filters for correct installation