Assembly - Bissell CleanView 3003 Series User Manual

Assembly

WARNING
Do not operate vacuum with damp or wet fi lters or without all fi lters in place fi rst.
1. Connect Hose to vacuum by inserting Hose
Connector on the end of the Hose into the suc-
tion inlet. Make sure the Hose is positioned so
the tabs on the Hose Connector line up with the
notches on the suction inlet.
2. Connect Hose handle to the end of the
Extention Wand and twist slightly to tighten.
3. Connect Floor Nozzle to the end of the
Extension Wand and twist slightly to tighten.
4. Once assembled, you can store your
vacuum by inserting the storage clip (located on
the back of the Floor Nozzle) into the storage
slot on the rear of the vacuum.
Colors and styles may vary from models shown.
1. 1. 2.
3. 3. 3. 4.
www.BISSELL.ca
5