Table of Contents
Advertisement
Maintenance & Care
Cleaning the Dirt Tank Filter
Use only BISSELL® replacement filters in
your vacuum.
1. Unplug the vacuum from the electrical outlet.
2.
2. The Dirt Tank filters can be reached by
removing the tank from the vacuum, and unclip-
ping the tank lid then pivoting
backwards. Pull filter upwards to remove.
3. The tank filter can be hand washed in cold
3.
water with a mild detergent. Rinse well and air
dry thoroughly before placing back onto the fil-
ter frame base.
4. Close tank lid and replace tank back onto the
vacuum.
Cleaning the Cyclone
1. Remove the Dirt Tank from the tank
1.
2.
lid and Cyclone assembly by twisting it
counter-clockwise and pulling away.
2. Remove the Cyclone by twisting it clockwise
then pulling down and away from
the Dirt Tank lid, over the secondary cyclone
fine dirt collector.
3. The Cyclone can be washed in cold water with
a mild detergent. Make sure it is completely dry
before replacing.
4. Replace the Cyclone by sliding it
3.
4.
over the bottom of the secondary cyclone fine
dirt collector and lining it up with the lock/
unlock arrow before twisting counter-clockwise
until you feel a click.
5. Replace the Dirt Tank and twist clockwise
to lock.
Replacing the Post-Motor Filter
The post-motor filter assists in the filtration
process to return cleaner air to the room. Use
only BISSELL® replacement filters.
1. Unplug the vacuum from electrical outlet.
2. Remove the filter door (located in the wheel
next to the ON/OFF switch of the vacuum) by
twisting it counter-clockwise and pulling out and
away from the vacuum
3. The post-motor filter can be hand washed in
cold water with a mild detergent. Rinse well and
air dry thoroughly before placing back into the
vacuum.
4. Replace the filter door by aligning the tabs up
with the slots on inside the wheel and turning
clockwise until you feel a click.
8
www.BISSELL.ca
Advertisement
Table of Contents
