Options Replacement - YASKAWA VS mini J7 Replacement Instructions Manual

5

Options Replacement

Refer to the table below for an overview about the replacement of options, which might be installed at the
drive that has to be replaced. Replace an option only by the appropriate new type and never try to apply
any not mentioned option or J7 option to the J1000.
Type Description
Interface for Remote operator
Interface for RS-232 PC
Serial
communication (Memobus)
communications
Interface for RS-422/485
communication (Memobus)
Remote operator without
potentiometer
Remote operator with
Operator panel
potentiometer
Extension cable 1 m
Extension cable 3m
To use a potentiometer on the
Potentiometer
drive for setting up the frequency
Option
reference.
DIN rail Used to mount the drive on a DIN
mounting rail.
AC reactors
DC reactors
J7
SI-232/J7
SI-232/J7C
SI-485/J7
JVOP-146
JVOP-144
WV001
WV003
Built in
EZZ08122x
UZBA-B
UZDA-B
VAN-V07007E [J7→J1000] Replacement Instructions
J1000
SI-232/J
SI-232/JC
SI-485/J
JVOP-182
not available
WV001
WV003
AI-V3/J
Use the same.
When replacing a J7xA43P0
by a JA4A0009 a different
DIN rail mounting kit is
required!
same as J7
same as J7
8/16