Seat; Helmet Holding Cable - Yamaha TRACER 700 2020 Owner's Manual

Instrument and control functions

Seat

To remove the seat
Insert the key into the seat lock, turn it
counterclockwise, and then pull the
3
seat off.
2
ZAUM1406
1. Seat lock
2. Unlock.
To install the seat
Insert the projection on the front of the
seat into the seat holder, orient the
seat in order to insert the seat bracket
into the seat lock, push the rear of the
seat down to lock it in place, and then
remove the key.
EAUM3740
ZAUM1407
1. Projection
2. Seat holder
3. Seat bracket
1
4. Seat lock
TIP
Make sure that the seat is properly se-
cured before riding.
1
3
1
4
2
3-19

Helmet holding cable

The helmet holder is located under the
seat. A helmet holding cable is provid-
ed in the owner's tool kit to secure a
helmet to the helmet holder.
To secure a helmet with the helmet
holding cable
1. Remove the seat. (See page 3-19.)
2. Pass the helmet holding cable
through the buckle on the helmet
strap buckle as shown, and then
hook the cable loops over the hel-
met holder.
1
2
3
ZAUM1408
1. Helmet strap buckle
2. Helmet holding cable
3. Helmet holder
EAUM3800