Instrument and control functions
other drivers when your vehicle is
stopped where it might be a traffic haz-
ard.
With the main switch in the on position,
set the hazard lights switch to " " to
3
turn on the hazard lights. The main
switch can then be turned to the off po-
sition or lock position, however the
hazard lights will continue flash. To
turn off the hazard lighs, turn the main
switch to the on position and set this
switch to "OFF".
NOTICE
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
tery may discharge.
Trip/info switch "TRIP/INFO"
This switch is used to make setting and
display changes in the multi-function
meter unit. See page 3-6 for more in-
formation.
Clutch lever
1
1. Clutch lever
ECA10062
To disengage the drivetrain from the
engine, such as when shifting gears,
pull the clutch lever toward to the han-
dlebar. Release the lever to engage the
clutch and transmit power to the rear
wheel.
TIP
EAUM3720
The lever should be pulled rapidly and
released slowly for smooth shifting.
(See page 5-3.)
EAU12823
Shift pedal
ZAUM1342
1. Shift pedal
The shift pedal is located on the left
side of the motorcycle. To shift the
transmission to a higher gear, move
the shift pedal up. To shift the trans-
mission to a lower gear, move the shift
pedal down. (See page 5-3.)
3-13
EAU12876
1