Cleaning And Lubricating The Drive; Chain - Yamaha TRACER 700 2020 Owner's Manual

Hide thumbs Also See for TRACER 700 2020:
Table of Contents

Advertisement

Periodic maintenance and adjustment
1
ZAUM1427
1. Drive chain slack adjusting bolt
6
TIP
Using the alignment marks on each
side of the swingarm, make sure that
both drive chain pullers are in the same
position for proper wheel alignment.
1
ZAUM1428
1. Drive chain puller
2. Notch
3. Alignment marks
3. Tighten the axle nut, then the lock-
nuts to their specified torques.
Tightening torques:
Axle nut:
150 N·m (15 kgf·m, 108 lb·ft)
Locknut:
16 N·m (1.6 kgf·m, 12 lb·ft)
4. Make sure that the drive chain
pullers are in the same position,
the drive chain slack is correct,
and
the
drive
smoothly.
2
3
2
6-24
Cleaning and lubricating the
drive chain
The drive chain must be cleaned and
lubricated at the intervals specified in
the periodic maintenance and lubrica-
tion chart, otherwise it will quickly wear
out, especially when riding in dusty or
wet areas. Service the drive chain as
follows.
NOTICE

chain

moves
The drive chain must be lubricated
after washing the motorcycle, riding
in the rain or riding in wet areas.
1. Clean the drive chain with kero-
sene and a small soft brush.
NOTICE: To prevent damaging
the O-rings, do not clean the
drive chain with steam cleaners,
high-pressure washers or inap-
propriate solvents.
2. Wipe the drive chain dry.
3. Thoroughly lubricate the drive
chain with a special O-ring chain
lubricant. NOTICE: Do not use
engine oil or any other lubri-
cants for the drive chain, as they
EAU23026
ECA10584
[ECA11122]

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mtt690 2020Mtt690-u 2020

Table of Contents