Raymarine E66008 Owner's Handbook Manual page 46

40
To attach the transducer cable connector:
1. Slip the nut over the connector cable end. Push it past the connec-
2. Insert the wedge tool into the groove in the split of the split ring
3. Slip the split ring and wedge tool over the connector body until
4. Remove the wedge tool and seat the split ring in the mounting
5. Slip the nut forward until it stops. Twist until the protrusions on
6. Slip the nut forward and snap into place.
The transducer cable is attached to the 7 pin male connector marked
TRANSDUCER on the fishfinder. How you connect the cable to the unit
depends on the type of transducer you have installed:
• Combined depth/speed/temp transducers have a 7 pin female
• Combined speed/temperature transducers have a 3 pin female
• Depth-only transducers have a 7 pin female connector.
• If being installed in conjunction with a speed/temperature trans-
Note:
sion cable, ensure that you connect the Y-cable to the fishfinder and
the extension cable to the transducer.
All manuals and user guides at all-guides.com
tor and over the cable.
and slide the wedge tool until its squared end is flush with the
larger edge of the split ring.
aligned with the mounting groove on the connector.
groove, making sure the connector protrusion falls into the split.
the inside of the nut align with the grooves on the split ring.
connector. Attach the transducer cable connector directly to the
fishfinder.
connector that requires the use of an additional Y-shaped cable
(Raymarine part number E66022) to attach to the 7 pin connector
on the fishfinder. This Y-cable is included with your speed/tem-
perature transducer.
Attach the 7 pin female connector on the Y-cable to the fishfinder
unit then attach the transducer cable to the 3 pin male connector
on the Y-cable.
Attach the transducer cable connector directly to the fishfinder.
or
ducer, attach the 7 pin female connector on the Y-cable to the fish-
finder then attach the transducer cable to the 7 pin male connector
on the Y-cable.
If your system requires both a Y-cable and a transducer exten-
Transducers for Fishfinders