Raymarine E66008 Owner's Handbook Manual page 32

26
Safety ring
Cap nut
Stem
Backing block
Figure 2-9:
8. If a fairing is used, apply marine sealant to the flat side of the tri-
CAUTION:
For smooth water flow over the transducer's sensor, be sure that
the external surface of the installed triangular plug is FLUSH
with the external curved surface of the fairing.
9. Being sure the valve assembly is seated firmly in the housing,
10. Remove any excess sealant on the outside of the hull to ensure
All manuals and user guides at all-guides.com
Fore View of Transducer Installation
angular plug. Push the plug into the triangular recess in the fair-
ing. The triangular plug fits one way only. Be sure the curved
side of the plug is exposed, matching the curve on the outside of
the fairing. Tap it into place with a mallet.
carefully screw the cap nut in place. Hand tighten it only; do not
over tighten.
smooth water flow over the transducer.
Transducers for Fishfinders
D4863-2
Cable
Safety chain
Pull ring
Retaining pin
Safety wire
Hull nut
Hull
Fairing
Transducer